AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Fldigi icom 730012/6/2023 ![]() The antenna was connected to the Icom 7300 and I was running FT-8 as a stress test. I used an FT140-43 toroid with 3 turns of wire to tune in 20m (14.070 MHz) at about 1.6:1 min SWR. I setup the capacitor with the PETG dielectric in the RG-213 coax loop as before. Will be interesting to see how HF works especially with an NVIS antenna. The FT-817 is nice in that it can work VHF & HF with the Signalink. My next experiments will likely center around setting up an NVIS antenna for HF and getting setup on my portable rigs. Packet VHF works well except I am still have an issue when using K5RAV-10 in which I can send email but not receive it.Īll in all, it looks like the setup works for both HF and VHF WinLink. VARA FM works quite well and is relatively fast. On VHF packet there are several new stations that I can use. Here again I was able to complete an exchange with HF stations up the state from here. I adjusted the output signal to indicate 1/3 of the ALC range. On the IC-7300 be sure to select CV-I for PTT method and leave DTS and RTS unchecked. I downloaded and installed VARA HF and was able to get it setup with minimal issue. I had the best luck with stations up state on 40m and was able to verify connections and exchanges. We have local HF stations now on 40m, 30m and 20m but I could not access them. ![]() I found these instructions useful for the IC-7300 ARDOP setup. On HF I found that the old WINMOR method has largely been replaced by ARDOP and VARA is of course available as well. ![]() I don’t use WinLink too often, especially on HF, but with the recent local repeater changes on VHF I decided to test as many access modes so I don’t fumble around with setting when I may need them the most.
0 Comments
Read More
Leave a Reply. |